Edgetech Model 3100P Sub-bottom Sonar System Manuale Scaricare il pdf (Pagina 44)

990-0000058-1000 Rev E Page 44

6.1. System Installation

Check that the unit power is turned OFF (switch position = DOWN).

Connect the 3100P Topside to a source of AC and/or DC power using either the DC Power &

Ethernet cable or the AC power cable. (Check system power specifications).

WARNING: DO NOT EXTEND THE DC POWER LEADS OF THE DC POWER &

ETHERNET CABLE.

Connect the 3100P Topside via the Tow cable connection to the Tow Vehicle using the supplied

tow cable. For detailed cable drawings, refer to Section 10. Connect the Notebook Computer to

the 3100P Topside using either the Wireless connection, or via the 100BaseT direct Ethernet

cable (which is part of the DC Power & Ethernet cable assembly). The Ethernet cable may be

extended up to 100 feet using a Category 5 Ethernet patch cable and Ethernet connector. A

crossover or direct cable may be used.

Figure 6-1 3100P Portable Processor Case Interface

Operate the ON/OFF switch to the ON position (switch position = UP).

Note: The ON/OFF switch operates in both the AC and DC power input modes.

Observe the side panel LEDs. The desired LED status for normal operation should be:

Power RED = ON

System Ready GREEN = ON

Ping (transmit) YELLOW = OFF or FLASHING

6. System Installation and Connections

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 74 75

Nessun commento

Edgetech Model 3100P Sub-bottom Sonar System Manuale Pagina 44